R23
EEE · 4-1
✓ VERIFIED VS. PUBLISHED SYLLABUS 2026-07-12
Power System Operation and Control
JNTUK R23 · EEE · semester 4-1 · syllabus
This JNTUK R23 professional core course is listed for Electrical and Electronics Engineering (EEE). It is listed in semester 4-1. It carries 3 credits. The published coverage runs across 5 units, from Unit I through Unit V.
Verified vs. published syllabus
Checked 12 Jul 2026
SOURCE DOCKET
Published evidence
✓ Verified
Checked 12 Jul 2026
Record 5 published units
Verification scope The course structure, credits, and unit-wise syllabus are sourced directly from JNTUK's official R23 EEE course structure and syllabus.
5 units, from Unit I to Unit V. Tick off units as you cover them — your progress stays on this device.
Unit-wise syllabus
0 / 5 COVERED
UNIT 01 — Unit I
Economic Operation of Power Systems Optimal operation of Generators in Thermal power stations - – Heat rate curve – Cost Curve – Incremental fuel and Production costs – Input–output characteristics – Optimum generation allocation with line losses neglected – Optimum generation allocation including the effect of transmission line losses – Loss Coefficients – General transmission line loss formula.
UNIT 02 — Unit II
Hydrothermal Scheduling Mathematical Formulation – Short term Solution Technique. Unit Commitment Need for unit commitment – Constraints in unit commitment – Cost function formulation – Solution methods – Priority ordering – Dynamic programming.
UNIT 03 — Unit III
Load Frequency Control-I Modelling of steam turbine – Generator – Mathematical modelling of speed governing system – Transfer function – Necessity of keeping frequency constant. Definitions of Control area – Single area control system – Block diagram representation of an isolated power system – Steady state analysis – Dynamic response – Uncontrolled case. Proportional plus Integral control of single area and its block diagram representation – Steady state response.
UNIT 04 — Unit IV
Load Frequency Control-II Block diagram development of load frequency control of two area system: uncontrolled case and controlled case – Tie-line bias control – Load frequency control and economic dispatch control.
UNIT 05 — Unit V
Compensation in Power Systems Overview of Reactive Power control – Reactive power compensation in transmission systems – Advantages and disadvantages of different types of compensating equipment for transmission systems – Load compensation – Specifications of load compensator – Compensated transmission lines. Introduction of FACTS devices – Need of FACTS controllers – Types of FACTS devices.